![]() ![]() High Voltage Secondary R.M.S.: 550 V.C.T. Mounting Hole Center to Center B: 2.688 in.Ī.C. The next job was to hoist the Plate Powerstat into place and set it temporarily on the 2x4 boards. This 700 LB rated block was used to get holt of the transformer and swing/drag it carefully into the rack. Mounting Hole Center to Center A: 2.5 in. A smaller one could have been used but this was available and inexpensive. We make exceptions when we see the same transformer ordered over and over again within a relatively short period of time. Note: Gray wire is actually BROWN on only our Part Number P-T278CX.įor those customers who are seeing too high a secondary voltage due to higher primary line voltages (roughly 125V input) - use the White & Black wire and tape the gray wire (see schematic).ĬAUTION: NEVER connect power to BOTH the GRAY & BLACK wire - instantaneous destruction of the transformer will result! ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |